Delta RPI M50A_120 User Manual

8 Settings
Installation and Operation Manual for RPI M50A
66
Installation and Operation Manual for RPI M50A
66
8.8.5 P Ramp Up
Overview
With this function you can de ne a ramp for the active power in case the inverter has disconnected from the grid
because of a grid voltage or grid frequency failure (see “8.8.2 Voltage protection”, p. 61 and “8.8.3 Frequency
protection”, p. 63). When the failure disappears, the inverter will continuously increase the active power fed
into the grid according to the set ramp.
Accessing the menu
Main menu > Install Settings > Grid settings > P Ramp Up
E-Today: 0kWh
Power: 0W
Status: On Grid
10.Sep 2014 15:32
1. When the default information is displayed, press any button to open the
main menu. Otherwise, repeatedly press the button
ESC
until the main
menu is displayed.
Inverter Info.
General Settings
Install Settings
Active/Reactive Pwr
FRT
2. Use the buttons and to select Install Settings.
To con rm your selection, press the button
ENT
.
3. Type in the password you received from Delta Support. Use the buttons
and to set each digit.
To con rm a digit, press the button
ENT
.
Grid Settings
Country
Insulation
Inverter ID: 001
4. Use the buttons and to select Grid settings.
To con rm your selection, press the button
ENT
.
Freq. Protection
Reconnect T: 600s
P Ramp up: 6000%/m
Voltage Protection
5. Use the buttons and to select P Ramp Up.
This subsection consists of only one parameter which can be directly
edited.
6. To start editing the parameter value, press the button
ENT
.
7. To change the parameter value, use the buttons and .
To con rm your setting, press the button
ENT
To cancel the action, press the button
ESC
.
Con gurable Parameters
Parameter Description
P Ramp up
Do not change this setting without prior
consultation with Delta Solar Support.

Delta RPI M50A_120 Specifications

General

Brand	Delta
Model	RPI M50A_120
Category	Inverter
Language	English