Delta RPI M50A_120 User Manual

83
Installation and Operation Manual for RPI M50A
8 Settings
83
Installation and Operation Manual for RPI M50A
8.18 FRT (Fault Ride Through)
Overview
Values have been set based upon country standards. If you modify these values, you will lose certi-
 cation. Therefore you should set this function only when requested by country regulations, authori-
ties or your grid operator.
With this function you can set the operation behavior of the inverter for FRT (Fault Ride Through).
Fig. 8.28: Operation behavior for FRT (Fault Ride Through)
t1 : The point in time when the fault occurs.
Accessing the menu
Main menu > FRT
E-Today: 0kWh
Power: 0W
Status: On Grid
10.Sep 2014 15:32
1. When the default information is displayed, press any button to open the
main menu. Otherwise, repeatedly press the button
ESC
until the main
menu is displayed.
Inverter Info.
General Settings
Install Settings
Active/Reactive Pwr
FRT
2. Use the buttons and to select FRT.
To con rm your selection, press the button
ENT
.
3. The menu is protected by password 5555. Use the buttons and
to set each digit.
To con rm a digit, press the button
ENT
.
Do not change this setting without prior
consultation with Delta Solar Support.

Delta RPI M50A_120 Specifications

General

Brand	Delta
Model	RPI M50A_120
Category	Inverter
Language	English