Delta RPI M50A_120

71
Installation and Operation Manual for RPI M50A
8 Settings
71
Installation and Operation Manual for RPI M50A
Set Point: 100%
Mode: ON
6. To change the mode, use the buttons and and press the but-
ton
ENT
.
To switch the function on, select ON and press the button
ENT
.
To switch the function off, select OFF and press the button
ENT
. When
you switch the function off, you can ignore the following steps.
Set Point: 100%
Mode: ON
7. To set the value for the power limitation, use the buttons and
to select Set Point and press the button
ENT
8. Use the buttons and To change the parameter value.
To con rm your setting, press the button
ENT
To cancel the action, press the button
ESC
.
Con gurable Parameters
Parameter Description Value range
Mode
Switches the function on and off.
ON | OFF
Default value: OFF
Set Point
The value for the power limitation.
0 .. 100%
Default value: 100%
Do not change this setting without prior
consultation with Delta Solar Support.