ENGLISH FRANCAIS
oSAFETY PRECAUTIONS
SAFETY INSTRUCTIONS
13. Power-Cord Protection - Power-supply cords should be routed so that they
are not likely to
be
walked on or pinched by items placed upon or against
them, paying particular attention to cords at plugs, convenience receptacles,
and the point
where
they exit
from
the product.
14. Outdoor Antenna Grounding - If
an
outside antenna or cable
system
is
connected to the product.
be
sure the antenna or cable system
is
grounded
so
as
to
provide some protection against voltage surges and built-up static
charges. Article 810
of
the
National Electrical Code, ANSI/NFPA 70, provides
information
with
regard to proper grounding of the mast and supporting
structure, grounding
of
the lead-in
wire
to
an
antenna discharge unit, size
of
grounding conductors, location of antenna-discharge unit, connection to
grounding electrodes, and requirements for the grounding electrode. See
Figure
A.
15. Lightning - For added protection for this product during a lightning storm,
or
when
it
is
left unattended and unused for long periods of time, unplug it
from the wall outlet and disconnect the antenna or cable system. This will
prevent damage
to
the product due
to
lightning and power-line surges.
16.
Power Lines - An outside antenna system should not
be
located
in
the
vicinity of overhead
power
lines or other electric light or
power
circuits, or
where
it
can
fall into such
power
lines or circuits. When installing
an
outside
antenna system, extreme care should be taken
to
keep from touching such
power
lines or circuits
as
contact
with
them
might
be
fatal.
17. Overloading - Do
not
overload wall outlets, extension cords, or integral
convenience receptacles
as
this
can
result
in
a risk of fire or electric shock.
18. Object and Liquid Entry - Never push objects of any kind into this product
through openings
as
they may touch dangerous voltage points or short-out
parts that could result
in
a fire or electric shock. Never spill liquid of any kind
on the product.
19.
Servicing - Do not
attempt
to
service this product yourself
as
opening or
removing covers may expose you to dangerous voltage or
other
hazards.
Refer
all
servicing
to
qualified service personnel.
20. Damage Requiring Service - Unplug this product from the wall outlet
and refer servicing
to qualified service personnel under the following
conditions:
a)
When the power-supply cord or plug is damaged,
b)
If liquid has been spilled,
or
objects have fallen into the product,
c)
If the product has been exposed
to
rain or water,
d)
If the product does not operate normally by following the operating
instructions. Adjust only those controls that are covered by the operating
instructions
as
an
improper adjustment
of
other controls
may
result
in
damage and will often require extensive
work
by a qualified technician to
restore the product
to
its normal operation,
e)
If the product has been dropped or damaged
in
any way, and
f)
When the product exhibits a distinct change
in
performance - this
indicates a need for service.
21. Replacement Parts - When replacement parts are required, be sure the
service technician has used replacement parts specified by the manufacturer
or have the same characteristics
as
the original part. Unauthorized
substitutions may result
in
fire, electric shock, or other hazards.
22.
Safety Check - Upon completion of any service or repairs to this product,
ask the service technician to perform safety checks
to
determine that the
product
is
in
proper operating condition.
23.
Wall or Ceiling
Mounting
- The product should
be
mounted
to
a wall or
ceiling only
as
recommended by the manufacturer.
24. Heat - The product should be situated away from heat sources such
as
radiators, heat registers, stoves, or other products (including amplifiers) that
produce heat.
ANTENNA
LEAD IN
WIRE
ANTENNA
DISCHARGE UNIT
(NEG
SECTION 810·20j
FIGURE A
EXAMPLE
OF
ANTENNA
GROUNDING
AS
PER
NATIONAL
ELECTRICAL CODE
Read
Instructions - All the safety and operating instructions should be read
before the product is operated.
Retain Instructions - The safety and operating instructions should be
retained
for
future reference.
Heed Warnings - All warnings
on
the product and
in
the operating
instructions should be adhered to.
Follow Instructions - All operating and use instructions should
be
followed.
Cleaning - Unplug this product from the wall outlet before cleaning. Do not
use liquid cleaners or aerosol cleaners.
Attachments - Do not use attachments not recommended by the product
manufacturer
as
they may cause hazards.
Water and MOisture - Do not use this product near
water
- for example,
near a bath tub, wash bowl, kitchen sink, or laundry tub;
in
a
wet
basement;
or near a
swimming
pool; and the like.
Accessories - Do not place this product on
an
unstable cart, stand, tripod,
bracket. or table. The product may fall, causing serious injury to a child
or adult, and serious damage
to
the product. Use only
with
a cart, stand,
tripod, bracket, or table recommended by the manufacturer, or sold
with
the product. Any
mounting
of the product should
follow
the manufacturer's instructions, and should
use a mounting accessory recommended by the
manufacturer.
A product and cart combination should be moved
with
care. Quick stops, excessive force, and
uneven surfaces may cause the product and cart
combination
to
overturn.
Ventilation - Slots and openings
in
the cabinet are provided for ventilation
and
to
ensure reliable operation
of
the product and to protect it from
overheating, and these openings
must
not
be
blocked or covered. The
openings should never be blocked by placing the product on a bed, sofa,
rug, or other similar surface. This product should
not
be placed
in
a built-in
installation such
as
a bookcase or rack unless proper ventilation
is
provided
or the manufacturer's instructions have been adhered to.
Power Sources - This product should be operated only
from
the type
of
power
source indicated on the marking label. If you are
not
sure
of
the type
of
power
supply
to
your home, consult your product dealer
or
local
power
company. For products intended to operate from battery power, or other
sources, refer to the operating instructions.
Grounding
or
Polarization - This product may
be
equipped
with
a polarized
alternating-current line plug
(a
plug having one blade
wider
than the other).
This plug
will
fit
into the
power
outlet only one way. This is a safety feature.
If you are unable to insert the plug fully into the outlet, try reversing the
plug. If the plug should still fail
to
fit, contact your electrician
to
replace your
obsolete outlet. Do not defeat the safety purpose
of
the polarized plug.
__
POWER SERVICE
GROUNDING
ELECTRODE SYSTEM
NEG·
NATIONAL ELECTRICAL CODE
(NEG
ART
250. PART
H)
2.
1.
4.
5.
3
7.
6.
8.
10.
9
12.
11.
The lightning flash
with
arrowhead symbol,
within
an
equilateral
triangle,
is
intended
to
alert the user to the presence of
uninsulated "dangerous voltage"
within
the product's enclosure
that may be of sufficient magnitude to constitute a risk
of
electric
shock to persons.
The exclamation point within
an
equilateral triangle
is
intended
to
alert the user
to
the presence
of
important operating
and maintenance (servicing) instructions
in
the literature
accompanying the appliance.
A.
RISK
OF
ELECTR~C
SHOCK A
~
L..-_-=D:....::O:....:N:...=.O=T.=....=O-'-P=EN=-_--'
~
WARNING:
TO
REDUCE
THE
RISK
OF
FIRE
OR
ELECTRIC
SHOCK.
DO
NOT
EXPOSE
THIS
APPLIANCE
TO
RAIN
OR
MOISTURE.
CAUTION:
TO
REDUCE
THE
RISK
OF
ELECTRIC
SHOCK.
DO
NOT REMOVE
COVER
(OR
BACK).
NO
USER-SERVICEABLE
PARTS
INSIDE.
REFER
SERVICING
TO
QUALIFIED
SERVICE
PERSONNEL.
I
To Next Page
Loading...
Need help?
General
