ENGLISH
II
Symbols used
to
indicate buttons in this manual
Button located
on
both the main unit
and
the remote control
unit
)0
BUTTON
Button only
on
the main unit )0
<BUTTON>
Button only
on
the remote control unit
)0
[BUTTON]
[Selectable mode] IBrowse
mode
I IRemote
mode
I
Display location Main unit display
iPod
display
Playable
Audio file
0 0
files
Video file
0*
0
Remote
Active
control unit
0 0
buttons
(AVR-1709)
iPod
X
0
4
Press
[MODE]
and hold it down for a 2 seconds
or
more to select the display mode.
To
switch between modes, press and hold down the button.
When remote mode
is
active, "Remote"
is
displayed.
*:When using
an
ASD-3N or ASD-3W control dock for iPod.
• With the default settings, the
iPod
can
be
used connected to the
VCR
(iPod)
connector.
• Use the
RESTORER
mode to expand the low and high frequency
components of compressed audio files and achieve a richer sound.
The default setting
is
"Mode3"
(~page
37).
• Press
<ON/STANDBY>
or
[OFF]
and
set the AVR-1709's power to
the standby mode before disconnecting the
iPod.
Also switch the
input source to one to which "iPod Assign"
is
not assigned before
disconnecting the
iPod.
• When using
an
ASD-3N or ASD-3W control dock for
iPod,
refer to the
respective manual to operate.
_
....
~
-,.
"System
Setup"
-
"Input
Setup"
-
"iPod
Assign"
(~page
26)
Preparations
iPod® Playback
The
music
on
an
IPod
can
be
played
by
uSing
the control dock for
iPod
IASD-l
R,
ASD-3N
or
ASD-3W, sold separately)
The
operation
can
also
be
performed
uSing
the buttons
on
the
remote control unit
1Make.the necessary preparations.
CDSet
the
iPod
in
the DENON control dock for iPod.
(~See
the control dock for iPod's operating instructions.)
@Assign the control dock for iPod's input.
The input for the control dock for
iPod
is
assigned to
VCR
by
default.
iPod
is
a trademark of Apple Inc., registered
in
the
U.S.
and
other countries.
*
The
iPod
may only
be
used to copy or play contents that are not
copyrighted or contents for which copying or playback
is
legally
permitted for your private use
as
an
individual.
Be
sure to comply
with
applicable copyright legislation.
2
Either turn
<SOURCE
SELECT>
or
press
[iPod]
to
select the input source assigned in step
I-@ above.
3
Set
[SOURCE
CONTROL
1]
to "AUDIO" and
[SOURCE
CONTROL
2]
to ''iPodINETWORK''.
(~
page
47
"Remote Control Unit Operations")
[Rear]
L....-_-+-
[MODE]
[iPod]
...,
i~:-:
---+-
[TUNING
+-]
:~;
[ENTER]
"-'-""~'--
[.6.'V
C>
]
<SOURCE
SELECT>
~
r~~~
<ON/STANDBY>
<STATUS>
[Front]
[OFF]-H:>
[iPOd]~
[.]--i~~
[~]-+-e:O
[-1I-1~
[
......
],[~]~
[ENTER]
I @
[.6.
'V
C>]
I .
:'::
[SOURCE
_-"'---~1
CONTROl1]~1
. _
[SOURCE
~
CONTROL
2]
I
43