3
Contents
Company names and product names are trademarks or registered trademarks of their respective holders.
Copyright © 2017-2018 DGSHAPE Corporation
http://www.dgshape.com/
Thank you very much for purchasing this product.
To ensure correct and safe usage with a full understanding of this product's performance, please be sure to read
through this manual completely and store it in a safe location.
At the time of purchase, verify that the provided warranty is axed with the dealer's signature, address, and
purchase date. Keep this warranty in a safe location.
Unauthorized copying or transferal, in whole or in part, of this document is prohibited.
The contents of this document and the specications of this product are subject to change without notice.
The operation manual and the product have been prepared and tested as much as possible. If you nd any
misprint or error, please inform DGSHAPE Corporation.
DGSHAPE Corporation assumes no responsibility for any direct or indirect loss or damage that may occur through
use of this product, regardless of any failure to perform on the part of this product.
DGSHAPE Corporation assumes no responsibility for any direct or indirect loss or damage that may occur with
respect to any article made using this product.
Correcting the Milling Machine ..........................................................................................................................................................................................53
Retightening the Collet .........................................................................................................................................................................................................59
Regulator Maintenance (Emptying the Drain) .............................................................................................................................................................. 62
Regulator Maintenance (Cleaning the Bowl) .................................................................................................................................................................63
Replacing the Cleaning Tool ................................................................................................................................................................................................ 65
Chapter 4 Troubleshooting ................................................................................................................66
Machine Trouble ..............................................................................................................................................................67
Initial Operations Are Not Performed or Fail..................................................................................................................................................................67
The Operation Button Does Not Respond ......................................................................................................................................................................67
VPanel Does Not Recognize the Machine .......................................................................................................................................................................67
No Data Is Being Output to the Machine, or the Machine Will Not Operate Even Though Data Is Being Output ..............................68
The Computer Shuts Down When Connecting Multiple Machines ...................................................................................................................... 68
The Spindle Does Not Rotate ..............................................................................................................................................................................................69
The Ionizer Is Ineective (Milling Waste Collects around the Milling Area)........................................................................................................69
Compressed Air Does Not Come Out ............................................................................................................................................................................... 69
Automatic Correction Fails ................................................................................................................................................................................................... 70
The Milling Bur Management Information Was Lost .................................................................................................................................................. 70
The Cleaning Tool Is Not Eective .....................................................................................................................................................................................70
The Adapter Rattles ................................................................................................................................................................................................................70
Milling Quality Problems ...................................................................................................................................................71
The Milled Surface Is Not Attractive ..................................................................................................................................................................................71
There Is a Line of Level Dierence in the Milling Results ..........................................................................................................................................71
Chipping Occurs (Edges of Milling Products Become Chipped) ............................................................................................................................ 71
A Hole Opens in the Milling Results ..................................................................................................................................................................................72
The Dimensions of the Milling Results Do Not Match ................................................................................................................................................72
Installation Problems ........................................................................................................................................................73
Installing the Driver Separately ..........................................................................................................................................................................................73
Installing the Software and the Electronic-format Manuals Separately .............................................................................................................. 75
Driver Installation Is Impossible .........................................................................................................................................................................................76
Uninstalling the Driver ...........................................................................................................................................................................................................78
Uninstalling VPanel .................................................................................................................................................................................................................79
Responding to Error Messages ........................................................................................................................................80
To Next Page
Loading...