Starting Milling
39
Chapter 2 Milling
Use the mounting screw to x the milling bur holder in place.
Load the cleaning tool in the "Cleaning" stocker.
Insert the cleaning tool slowly into the stocker from directly above in order to prevent the bristles from getting caught
on the stocker and spreading out.
CAUTION
Do not needlessly insert or remove the cleaning tool.
Replacing the cleaning tool
If the bristles of the cleaning tool spread out, the cleaning tool will not be as eective in removing the milling waste. If the bristles
have spread out, replace the cleaning tool with a new one. Contact your authorized DGSHAPE Corporation dealer or visit our website
(http://www.dgshape.com/) to purchase items.
" P. 65 "Replacing the Cleaning Tool"
To Next Page
Loading...