Configuration menu System logging
Digi CM User Guide 159
You can access this menu through a Telnet or SSH session using the IP address of the Digi CM unit
followed by the port number 7000 as in the following example:
telnet 192.168.100.200 7000
By default root is connected to the command line interface and the preceding option allows the root
user access to the port access menu.
System logging
System logging is a two part process. First, the device being used to record the system logs must be
configured. Secondly, system logging must be configured for the system under System status and
log. System logs can be saved to the Digi CM unit’s system memory (there is no need to configure the
memory), a compact-flash card, an NFS server, or a SYSLOG server.
Configure the system log device
To configure the compact-flash card for system logging, see Add a compact-flash card. For an NFS or
SYSLOG server, do the following:
1 Access the configuration menu.
2 Choose Network configuration > NFS or SYSLOG server configuration.
3 Disable or enable the server.
To Next Page
Loading...
Need help?
General
