Configure security and authentication Configure User Access Control
Digi CM User Guide 73
If you check <<Everyone>>, all users, whether they are configured locally or are using a remote
authentication (such as LDAP or Kerberos), have access to this port.
If you do not check <<Everyone>>, no users are allowed to access this port unless they are
individually listed.
When you enter usernames for access permissions or restrictions, you must enter the username
exactly as the username on the remote authentication server or configured locally. The username is
case-sensitive.
In the next example, three users are configured on the Digi CM unit: Jeff, Tim and Paul. To give Tim
and Paul read/write access and power access to this port, you could either:
▪ Grant rights to Paul and Tim
▪ Restrict Jeff’s rights
▪ Add users to an Access list (in this example. sun-users) found under System administration >
Access list. For more information, see Create an Access list.
Configure user access privileges
To configure user access privileges:
1 Select Serial Port Configuration > All Ports (or Port #)
2 Click User access mode
3 Enter the users and their privileges, and click Add user.
To Next Page
Loading...
Need help?
General
