Install and configure PC cards Add a wireless LAN card
Digi CM User Guide 30
5 Click Save & apply.
Note If DHCP is active the IP address will appear after the configuration is saved and applied.
Add a wireless LAN card
To install and configure a wireless LAN card on the Digi CM unit, do the following.
1 Insert the card into the PC slot.
2 Access the web interface.
3 Under the PC card heading, click Configuration.
Note The card is automatically discovered and a configuration menu is displayed.
4 Click Configure the detected card.
5 Enter the appropriate parameters in the configuration menu.
WEP is the acronym for Wired Equivalent Privacy and is a security protocol for wireless LANs
using encryption to protect data transfers. If you are unsure of the settings for the wireless card,
see your network administrator.
SSID - Set Service Identifier and is the name of the wireless LAN network
Use WEP key - Enable or disable the WEP key
To Next Page
Loading...
