Configuration menu Firmware upgrade
Digi CM User Guide 172
5 Choose Enable/Disable unit clustering > Enable.
6 Enter the values for Slave Unit IP, No. of ports, and Port configuration.
7 Select the port number to configure or 0 for all ports.
8 Select Enable configuration
9 Select Auto Configuration
10 Choose Exit and apply changes.
Firmware upgrade
Before upgrading firmware from the configuration menu you should have:
▪ Downloaded the firmware to a system on the same subnet
▪ Set up a terminal emulation program that supports Zmodem transfer protocol
To upgrade the firmware with the configuration menu, do the following:
1 Access the configuration menu.
2 Choose System administration.
To Next Page
Loading...
