Microsoft SAC support About the Digi CM Unit’s support for Microsoft Windows Server 2003
Digi CM User Guide 89
About the Digi CM Unit’s support for Microsoft Windows Server
2003
The Digi CM unit provides a browser-based user interface to Microsoft’s text-based Special
Administration Console (SAC), an integral part of Windows Server 2003 Emergency Management
Services (EMS). Both the English and Japanese versions of SAC are now supported. When a server
running Windows Server 2003 is connected to the Digi CM unit’s serial port, key SAC functions--
normally accessed from the command line--are available from a graphical user interface (GUI). SAC
features accessible from this interface include:
▪ Reset and shutdown
▪ Show performance values like memory utilization
▪ Show and configure IP settings per interface
▪ Show the process list and kill processes
Note While the EMS port is available at all times using Telnet or SSH, the special GUI is available
only while SAC is active.
Setup overview
Setup for the Digi CM unit SAC support is a three-step process:
1 Set up the Windows Server 2003 for SAC support. To do this, ensure that the COM port used for
console traffic is properly set up. This includes designating a COM port for console
communication and setting the port speed (baud) appropriately. For further information see
Setup the Windows Server 2003 port below.
To Next Page
Loading...
Need help?
General
