Digi CM 8 User Manual

System status and port logging Enable the log storage location
Digi CM User Guide 38
Enable the Digi CM unit’s memory
The Digi CM unit ’s memory is already enabled for port logging and needs to be configured only for
system logs or port logs. When storing log files to the Digi CM unit’s local memory, a total of 3.5M is
available. The amount of memory per serial port is dependent on the port count of the Digi CM unit
used. The log file sizes shown in the following table are maximum settings. See also Configure
system logging.
Total flash card size Digi CM System log Port log (per port) Total memory used
32 8 4.6 3.1M 29M
16 4.6 1.53M
32 4.6 762K
48 4.6 500K
64 8 9.2 6.2M 58M
16 9.2 3.1M
32 9.2 1.53M
48 9.2 1.02M
128 8 18.4 12.3M 118M
16 18.4 6.2M
32 18.4 3.1M
48 18.4 2.0M
256 8 36.8 24.6M 236M
16 36.8 12.3M
32 36.8 6.2M
48 36.8 4.1M
Digi CM System log Port log (per port) Total memory used
8 300K 400K 3.5M
16 200K
32 100K
48 66K

Digi CM 8 Specifications

General

Brand	Digi
Model	CM 8
Category	Network Hardware
Language	English