42 ECLYPSE APEX
3. Login to the controller. Then set the controller’s configuration parameters in the controller’s config-
uration Web interface. See Connecting to the Controller's Configuration Web Interface.
The Hostname can be changed in the System Settings.
Using the Controller's IP Address in the Web Browser
Connect to a controller through its IP address as follows:
For a Wi-Fi network connection
1. Open your Web browser.
2. In the Web browser’s address bar, type https://192.168.0.1 (the controller’s factory-default wire-
less hotspot IP address) and click go.
3. Login to the controller. Then set the controller’s configuration parameters in the controller’s config-
uration Web interface. See Connecting to the Controller's Configuration Web Interface.
Not all smart phones/mobile devices have the Bonjour service installed and thus cannot use the hostname mechanism.
For an Ethernet network connection
You must know the controller’s current IP address (from the DHCP server for example).
4. Open your Web browser.
5. In the Web browser’s address bar enter the controller’s IP address and click go.
6. Login to the controller. Then set the controller’s configuration parameters in the controller’s config-
uration Web interface. Connecting to the Controller's Configuration Web Interface.
Connecting to the Controller's Configuration Web
Interface
The ECLYPSE Series Controller configuration can be made through the controller’s configuration Web
interface to set all the controller’s configuration parameters including the controller’s IP address ac-
cording to your network planning.
At the first connection to an ECLYPSE Controller you will be forced to change the password to a
strong password for the admin account to protect access to the controller.
It is important to create new user accounts with strong passwords to protect the controller from unau-
thorized access. See User Management, Securing an ECLYPSE Controller, Supported RADIUS Server Ar-
chitectures.
Next Steps
In Network Settings, configure the controller’s network parameters so that they are compatible with
your network. See ECLYPSE Web Interface.
First Time Connection to an ECLYPSE Controller
To Next Page
Loading...
Need help?
General
