Distech Controls ECLYPSE APEX User Manual

53ECLYPSE APEX
Wireless Configuration
This configuration interface is for any ECLYPSE Wi-Fi Adapter connected to the
HOST
connector.
A hotspot creates a subnetwork. As a result, any connected BACnet device will not be able to discover BACnet
devices on any other LAN subnetwork.
Figure39: The Wi-Fi network operating modes: Hotspot, Access-Point, or Client.
The Wireless connection parameters can be set as follows.
Item Description
On / Off
Enable/disable the controller’s wireless features.
Wireless Mode
Select the Wi-Fi network operating mode: Hotspot, Access-Point, or Client.
Hotspot
: This creates a Wi-Fi hotspot with a router. See Setting up a Wi-Fi Hotspot Wireless
Network for how to configure this mode.
Access-Point
: This creates a Wi-Fi access point. See Setting up a Wi-Fi Access Point Wireless
Network for how to configure this mode.
Client
: this connects the controller as a client of a Wi-Fi access point. See Setting up a Wi-Fi Client
Wireless Network for how to configure this mode. See also ECLYPSE Wi-Fi Adapter Connection
Modes.
SSID Hidden Hide or show the Service Set IDentification (SSID).
Network Name
The Service Set IDentification (SSID) for a Wi-Fi hotspot. This parameter is case sensitive. When
this controller’s active mode is configured as a:
For
Hotspot
: set a descriptive network name that other wireless clients will use to find this hotspot.
ECLYPSE Web Interface

Distech Controls ECLYPSE APEX Specifications

General

Brand	Distech Controls
Model	ECLYPSE APEX
Category	Control Systems
Language	English