User manual DPC Touch V2 DOC.60352-11/20
A job may contain up to 80 steps.
The maximum number of positions in a single fastening step is 50.
To change the sequence of steps in a job, tap the step once and then change
its position in the list by using the Up and Down buttons.
Created steps can be modified by using the EDIT button or deleted by using
the DELETE button. The COPY button creates a copy of the selected step and
inserts it at the end of the list.
Press the SAVE button to save the job, or the CANCEL button to quit
programming without saving changes.
The job name can be changed with the keypad by clicking on the actual name.
There must be at least one step in the job in order for a new job name to be
registered.
To Next Page
Loading...
