Dr.coffee M12 - Grinder and Thermo Block Disassembly

Rev 0.1
Dr.coffee Service Manual 66
10.2.10 Disassemble Grinder Group
Step 1：（pic.1）First remove the bean holder；
Step 2：（pic.3）press the buckle marked with the red circle to remove the Hall sensor group, and then unplug the wiring
plug on the power board（pic.4）
Step3：（Pic.5）Grab the parts of the grinder by hand, take out the whole grinder group upwards, and disassemble the grinder
group.
★ Attention：
1、Be careful during the disassembly process to prevent scratching your fingers！
4、 Before removing the grinder group, please empty the residual coffee beans and coffee powder in the grinder！
2
1
6
5
4
3