Dr.coffee M12 - Disassemble Thermo Block

Rev 0.1
Dr.coffee Service Manual 67
10.2.11 Disassemble Thermo Block
Step1：First pull out (as shown in Figure 1, 2) the red box marked the position of the wiring plug；
Then pull out (as shown in Figure 3, 4) the position of the wiring plug.；
Step3：Unplug (as shown in Figure 5) the four water pipe joints indicated by the arrow, and finally unscrew the fixing
screws at the position indicated by the red circle, remove the heating plate set outward, and disassemble it.
★ Attention：
1、Unplug the coffee machine before doing this！
2、Be careful during the disassembly process to prevent scratching your fingers！
5、 Please disassemble the coffee machine after it has cooled down completely, beware of burns.！
3
4
1
2
7
5
6