DSC WP8030 Installer's Guide

3. WP8010 INSTALLATION
D-306233 CUSDOC PM-10/30 V18 DSC TRIPLE EN INST 29
5.1.2 Feedback Sounds
The sounds you will hear while using and configuring the control panel are:
Sound
Definition
Single beep, heard whenever a key is pressed
Double beep, indicates automatic return to the normal operating mode (by timeout).
Three beeps, indicates a trouble event
♫
Happy Tune (- - - –––), indicates successful completion of an operation.
♫
Sad Tune (–––––), indicates a wrong move or rejection
You can control the volume level of the sounded beeps by pressing the button on the keypad to increase the
volume of the beeps heard, or by pressing the button to decrease the volume of the beeps heard.
5.2 Entering the "Installer Mode" and Selecting a Menu Option
All installer menu options are accessed via the "Installer Mode" which is usually one of the main panel menu options.
To enter the "Installer Mode" and select an Installer Menu Option proceed as follows:
Step 1

Step 2

Step 3

Step 4
Select "INSTALLER
MODE" Option
[1]
Enter
Installer Code
[2]
Select "Installer Menu" Option
[3]


See

See
READY 00:00
01:INSTALL CODES
5.3
08:USER SETTINGS
5.10
Go to
the
indicated
section
of the
selected
option

02:ZONES/DEVICES
5.4
09:FACTORY DEFLT
5.11
INSTALLER MODE
ENTER CODE:

03:CONTROL PANEL
5.5
10:SERIAL NUMBER
5.12
If the "Installer
Mode" is not shown,
refer to section 5.2.1
04:COMMUNICATION
5.6
12:PARTITIONING
5.13
05:OUTPUTS
5.7
13:OPERATION MOD
5.14
06:CUSTOM NAMES
5.8
<OK> TO EXIT
07:DIAGNOSTICS
5.9

 - Entering the "Installer Mode" menu
[1]
You can access the "Installer Mode" only when the system is disarmed. The process described refers to the
case where "User permit" is not required. If "User permit" is required, select the "User Settings" option and
ask the Master User to enter his code and then scroll the "User Settings" menu and select the "Installer Mode"
option (last option in the menu). Continue to Step 2.
[2]
If you have not already changed your Installer code number, use the default settings: 8888 for installer & 9999 for
master installer.
If you enter an invalid installer code 5 times, the keypad will be automatically disabled for a pre-defined period of
time and the message WRONG PASSWORD will be displayed.
[3]
You have now entered the "Installer Menu". Scroll and select the menu you wish and continue to its
corresponding section in the guide (indicated on the right side of each option).

DSC WP8030 Specifications

General

Brand	DSC
Model	WP8030
Category	Control Panel
Language	English