3. WP8010 INSTALLATION
D-306233 CUSDOC PM-10/30 V18 DSC TRIPLE EN INST 67
5.11 Factory Default
The FACTORY DEFLT menu enables you to reset the WP8010/WP8030 parameters to the factory default parameters.
To obtain the relevant parameters defaults, contact the WP8010/WP8030 dealer. Reset factory default parameters as
follows:
Select "09:FACTORY DEFLT"
menu
Resetting of factory default
parameters is underway
Notes:
1) For WP8010/WP8030 with 2 installer codes, INSTALLER code and MASTER INSTALLER code, only the master
installer code enables to perform the factory default function.
2) If the Soak Test
is active, performing factory default will restart the Soak Test.
5.12 Serial Number
The SERIAL NUMBER menu enables reading the system serial number and similar data for support purposes only. To
read the system serial number and other relevant data proceed as follows:
Select "10:SERIAL
NUMBER" menu
Click next repeatedly to view
relevant data.
Control panel serial number
WP8010panel software
version
WP8030panel software
version
Control panel keypad software
version
Control panel ID for
PowerManage connectivity
GSM image transfer software
version
WP8010panel default version
WP8030panel default version
Control panel boot version
Control panel Remote
Software Upgrade downloader
version
5.13 Partitioning
5.13.1 General Guidance – "Partitioning" Menu
This menu allows you to enable/disable partitions in the system (for further details, see APPENDIX B).
5.13.2 Enabling / Disabling Partitions
To enable or disable the partition feature, proceed as follows:
Select "12:PARTITIONING" menu
Select whether to "Enable" or "Disable"
Partitions
Partitions are
now enabled
Soak Test is not applicable for UL installations
Refers to WP8030 only
To Next Page
Loading...
Need help?
General
