3. WP8010 INSTALLATION
D-306233 CUSDOC PM-10/30 V18 DSC TRIPLE EN INST 3
1. INTRODUCTION
WP8010WP8030 are PowerG-enabled professional all-in-one wireless security, fire and safety systems supporting
advanced applications and DSC's new revolutionary PowerG™ Two-Way, Time Division Multiple Access (TDMA) and
Frequency Hopping Spread Spectrum (FHSS) wireless technology. This offers unmatched wireless robustness,
superior range and long battery life; a perfect and user friendly solution for both monitoring service providers and
professional installers.
This manual refers to WP8010/WP8030 and above. The most updated manuals can be downloaded from the DSC
Web site http://www.dsc.com.
Note: For UL installations, please contact the manufacturer for the most recent version of UL approved documentation.
The WP8010/WP8030 control panel is supplied with 2 instruction manuals:
Installer's Guide (this manual) – for use of system installer during system installation and configuration
User’s Guide -– also for use of system installer during system installation and configuration, but also for the master
user of the system, once installation is completed. Hand over this manual to the master user of the system.
1.1 System Features
The following table lists the WP8010/WP8030 features with a description of each feature and how to use it.
Visual Alarm
Verification
The WP8010/WP8030 when used with
PG9934 PIR-camera detector and GPRS
communication is able to provide the
Monitoring Station with clips captured in
alarm situations. The system sends the clips
to the Monitoring Station automatically for
burglary alarms and, depending on setup,
also for fire and personal emergency alarms.
Note: WP8010/WP8030 is compatible with
the following UL/ULC listed receivers: SG-
System I, SG-System III, SG-System IV.
1. Setup GPRS communication: see GSM
Module Installation (section 3.4 for WP8010
or section 4.6 for WP8030).
2. Configure camera settings: refer to the
PG9934 Installation Instructions.
3. Enable fire and personal alarm
verification: see section 5.6.6 Configuring
Motion Cameras for Video Alarm Verification.
On demand clips from
cameras
The WP8010/WP8030 can provide images
from the PG9934 by demand from a remote
PowerManage server. Pictures are taken
based on a command from the monitoring
station. To protect customers' privacy, the
system can be customized to enable the "On
Demand View" only during specific system
modes (i.e. Disarm, Home & Away) and also
to a specific time window following an alarm
event.
1. Setup the On demand feature: see
section 5.6.6 Configuring Motion Cameras
for Video Alarm Verification.
2. To request and view images: refer to the
PowerManage User's Guide, Chapter 5
Viewing and Handling Events.
PowerG devices are enrolled from the control
panel. "Pre-enrollment" can also be
performed by entering the PowerG device ID
number and then activating the device in the
vicinity of the panel.
To enroll or pre-enroll devices: see section
5.4.2 Adding New Wireless Devices or Wired
Sensors.
Device parameters and related system
behavior can be configured from the control
panel or from a remote location.
Each PowerG device has its own settings
which can be configured through the control
panel by entering the "DEVICE SETTINGS"
menu.
Note: The minimum configuration of the
system includes one detector.
To configure devices from the control
panel: see Chapter 5 Programming and also
the individual device's Installation
Instructions.
To configure devices from a remote
location: refer to the PowerManage User's
Guide Chapter 3 Working with Panels and to
the Remote Programmer PC software User's
Guide, Chapters 6 and 7.
To Next Page
Loading...
Need help?
General
