3. WP8010 INSTALLATION
62 D-306233 CUSDOC PM-10/30 V18 DSC TRIPLE EN INST
5.8.2 Record Speech
You can record short-duration speech messages for the house identity, user names and custom zone names.
For the recording procedure follow the instructions below. Additional details and guidance are provided in section 5.2.
06:CUSTOM NAMES
RECORD HOUSE ID
Enter "RECORD SPEECH", select the menu you wish to perform (see guidance above), then refer to the tables below
which provide you with detailed explanations for each option.
You can record a message to be announced automatically when events are reported to private
telephones.
While in "06:CUSTOM NAMES ", press ; the display now reads "RECORD HOUSE ID"
and alternates with "REC-<2> PLAY-<5>" (this means, press the button to record and
the button to play recording).
To initiate the recording procedure, press the button continuously to record your
message; "RECORD A MESSAGE" appears momentarily and then changes to
"TALK NOW
" (the square boxes slowly disappear, one by one, until the end of the
recording time).
At the end of the recording process, the panel will display the following:
"RECORDING ENDED". Release the button.
Note: To check the recorded message, press the button and listen to the playback.
To advance to the next stage in the recording procedure; from the "RECORD HOUSE ID" menu, click ; the display
now reads “RECORD USER NAME”. Press to proceed.
You can record ten user names and assign them to users 23-32. In case of event, the relevant
user name will be added to the message that will be reported via the telephone.
Record user names for 23-32; the procedure is identical to the "RECORD HOUSE ID"
recording procedure described above. Click to navigate between user name numbers.
To advance to the next stage in the recording procedure; from the "RECORD USER NAME" menu, click ; the
display now reads “RECORD ZONE NAME”. Press to proceed.
You can record zone names (for example, Garage door, Guest room, etc.), and assign them
to specific zones.
Press to select the zone name you wish to record, for example "VOICE LOC. #01" -
the display alternates with the current recording for zone name, for example, "Dining room".
Record zone names; the procedure is identical to the "RECORD HOUSE ID" recording
procedure described above.
Click to navigate between zone name numbers.
When done, press to return.
IMPORTANT!
1. The editing of a custom zone name automatically deletes the original text and recorded voice name. Make sure to
record a new voice name.
2. Performing reset of factory defaults (see section 5.11) restores the original recordings for the zone name.
Refers to WP80130 with voice option only
To Next Page
Loading...
Need help?
General
