3. WP8010 INSTALLATION
D-306233 CUSDOC PM-10/30 V18 DSC TRIPLE EN INST 5
Reporting to Private
Users and/or
Monitoring Station by
telephone, SMS and
IP communication
The WP8010/WP8030 system can be
programmed to send notifications of alarm
and other events to 4 private telephone
subscribers by voice and also to 4 SMS
cellular phone numbers and to report these
events to the Monitoring Station by SMS,
PSTN or IP communication
(IP communication not enabled in UL Listed
product).
To configure notifications to Private
phones: refer to the WP8010/WP8030-
User's Guide, Chapter 6, section B.12
Programming Private Phone and SMS
Reporting.
To configure reporting to the Monitoring
Station: see section 5.6.4 Configuring
Events Reporting to Monitoring Stations.
Quick installation with
link quality indication
With PowerG devices, there is no need to
consult the control panel when mounting a
wireless device, because PowerG devices
include a built-in link quality indicator.
Choosing the mounting location is a quick
and easy process.
To choose the ideal location to mount a
wireless device, see Chapter 2 Choosing the
Installation Location.
Helps you to easily identify the actual device
displayed on the LCD display.
To read more on the Device Locator: refer
to the WP8010/WP8030 User's Guide,
Chapter 2, Operating the WP8010/WP8030
System.
To use the device locator when bypassing
a zone or when clearing a bypassed zone:
refer to the WP8010/WP8030 User's Guide,
Chapter 6, section B.1 Setting the Zone
Bypass Scheme.
To use the device locator when
conducting the periodic test: see Chapter
6 Periodic Test or refer to the
WP8010/WP8030 User's Guide, Chapter 9
Testing the System.
WP8010/WP8030 is able to control a safe
that holds site keys that are accessible only
to the site's guard or Monitoring Station's
guard in the event of an alarm.
1. Connect the safe to the panel: see
section 3.6 Adding Wired Zones or PGM
Device, Figure 3.6b (WP8010) / section 4.9
Optional Expander Module Mounting, Figure
4.9b (WP8030).
2. Configure the safe's zone type to
"Guard Zone": see section 5.4.2 Adding
New Wireless Devices or Wired Sensors.
3. Setup guard code: see section 5.3
Setting Installer Codes.
External system may control arming and
disarming of the WP8010/WP8030 system.
1. Connect the external system output to
the panel: see section 3.6 Adding Wired
Zones or PGM Device, Figure 3.6b
(WP8010) / section 4.9 Optional Expander
Module Mounting, Figure 4.9b (WP8030).
Note: Monitoring Station means not evaluated by UL.
To Next Page
Loading...
Need help?
General
