Setting the stitch length adjusting wheels
Service Manual 867 Version 02.0 - 04/2015 31
12, 9, or 6 mm can be selected as the maximum stitch length. In doing so,
the appropriate throat plate has to be selected for the respective maximum
stitch length. The throat plate cut-out must be large enough that the feed-
dog does not hit against the edges of the throat plate at the front and rear
dead center.
Proper setting
Turn the upper stitch length adjusting wheel clockwise as far as it will go.
The upper stitch length adjusting wheel can only be turned up to the
maximum stitch length set.
Fig. 21: Setting the stitch length limit
Setting steps
1. Position the upper stitch length adjusting wheel (1) to 0.
2. Hold the upper stitch length adjusting wheel (1) using a key.
3. Loosen the screw (2).
4. Remove the upper stitch length adjusting wheel (1).
WARNING
Risk of injury
Crushing injuries from moving parts.
Switch off the sewing machine before setting the
maximum stitch length limit.
ATTENTION
Risk of damaging the feed-dog due to incorrect throat plate size
If the throat plate cut-out is too small, then the feed-dog can hit against
the edges.
Make sure that an appropriate throat plate is used for the maximum
stitch length set.
2
3
1
(1) - Upper stitch length adjusting wheel
(2) - Screw
(3) - Mark-off openings
To Next Page
Loading...
