DURKOPP ADLER M-TYPE 867 - Setting the Winder

Winder
62 Service Manual 867 Version 02.0 - 04/2015
14.2 Setting the winder
Proper setting
The winder wheel runs smoothly and without axial play.
The winding process will stop automatically when the required filling quan-
tity of the bobbin is reached.
Cover
• Arm cover ( 3.3.2 Removing and fitting the arm cover, page 13)
Fig. 49: Removing the winder and setting the winder filling quantity
Removing the winder
1. Loosen the screws (1).
2. Remove the winder.
Setting the winder filling quantity
The position of the arms on the screw (2) determines the filling quantity:
• Parallel: Automatic winding stop at 0.5 mm under the edge of the
winder
• Closer together: Automatic stop with larger filling quantity
• Further apart from each other: Automatic stop with smaller filling
quantity
3. Turn the screw (2):
• Arms closer together: Turn it counterclockwise
• Arms further apart from each other: Turn it clockwise
4. Put the completely filled bobbin onto the winder.
WARNING
Risk of injury
Crushing injuries from moving parts.
Switch off the sewing machine before setting the
winder.
2
3
4
1
(1) - Screws
(2) - Screw
(3) - Winding lever
(4) - Arm