DURKOPP ADLER M-TYPE 867 - Setting the Lower Stitch Length Adjusting Wheel

Setting the stitch length adjusting wheels
Service Manual 867 Version 02.0 - 04/2015 29
7.2 Setting the lower stitch length adjusting wheel
Checking the correct setting
Sewing with two different stitch lengths:
• The stitch lengths on the seam correspond with the set stitch lengths.
• The lower stitch length adjusting wheel can only be turned up to the
stitch length set on the upper stitch length adjusting wheel.
Cover
• Tilt the upper section ( 3.3.1 Access to the machine bottom section,
page 12)
Fig. 19: Setting the lower stitch length adjusting wheel I
Setting steps
1. Position the upper stitch length adjusting wheel (2) > 3.
2. Switch machine to short stitch length.
 The key for the stitch length (1) does not light up.
If the key lights up, press key (1) again.
WARNING
Risk of injury
The lower stitch length adjusting wheel has to be
set when the machine is switched on, because
a switchover is automatically made to the upper
adjusting wheel when the machine is switched off.
Carry out all work with extreme caution.
(1) - Keypad key for the machine arm
(2) - Upper stitch length adjusting wheel
(3) - Lower stitch length adjusting wheel
0
1
2
4
3
5
6
7
8
9
10
11
12
0
1
2
4
3
5
6
7
8
9
10
11
12
+/–
+/–
3
1
2