DURKOPP ADLER M-TYPE 867 - Setting the Hook Thread Guide

Winder
64 Service Manual 867 Version 02.0 - 04/2015
bobbin is 2 – 3 mm.
13.Set the clamp (5) such that it is resting against the locking disc (14).
14.Set the clamp (5) such that its distance to the winder wheel (6) is 0.5 mm.
15.Tighten the setscrew in the clamp (5).
Fig. 52: Installing the winder
Installing the winder
16.Fit the winder on the machine arm.
17.Tighten the screws (1).
14.3 Setting the hook thread guide
The position of the hook thread guide determines how the thread is wound
onto the winder.
Proper setting
The thread is wound on evenly over the entire width of the bobbin.
Fig. 53: Setting the hook thread guide
Setting steps
1. Loosen the screw (1).
1
.
(1) - Screws (2) - Marking for XXL hook
2
1
(1) - Screw (2) - Hook thread guide