Maintenance work
Service Manual 867 Version 02.0 - 04/2015 105
21 Maintenance work
21.1 Lubrication
Required oil:
Only DA 10 or equivalent oil should be used for the machine, which has
the following properties:
• Viscosity at 40 °C: 10 mm²/s - ISO VG10
• Flash point: 150 °C
DA 10 can be obtained under the following part number at DA sales
offices:
• 9047 000011 - 250 ml
• 9047 000012 - 1 l
• 9047 000013 - 2 l
• 9047 000014 - 5 l
WARNING
Risk of injuries due to contact with oil.
Contact with oil can cause irritation, rashes, aller-
gies or skin injuries.
ALWAYS avoid long-term contact with oil.
ALWAYS thoroughly wash the affected areas if con-
tact with oil occurs.
ENVIRONMENTAL PROTECTION
Risk of environmental damage from oil.
Oil is a pollutant and must not enter the sewage sys-
tem or the soil.
Carefully collect waste oil and dispose of the waste
oil and oil-contaminated machine parts in the legally
prescribed manner.
ATTENTION
Machine damage due to incorrect oil level
An incorrect oil type can cause damage to the machine.
Only use oil that complies with the data in the manual.
To Next Page
Loading...
