Setting the feed-dog
Service Manual 867 Version 02.0 - 04/2015 39
8.2.3 Setting the stroke movement
Order
First check the following setting:
• Feed-dog height ( 8.2.2 Setting the feed-dog height in the top dead
center, page 38)
Proper setting
At the front dead center (handwheel position 90°) and at the rear dead
center (handwheel position 270°) for the feed-dog, the upper edge of the
feed-dog is at the same height as the upper edge of the throat plates.
At 90°, the feed-dog is in the upward movement; at 270°, in the downward
movement.
Cover
• Tilt the upper section ( 3.3.1 Access to the machine bottom section,
page 12)
Fig. 27: Setting the feed-dog lift
Setting steps
1. Unscrew the setscrews (1).
2. Put the handwheel into the 90° position.
3. Turn the stroke eccentric (2) such that the upper edge of the feed-dog
is in the upward movement and at the same height as the upper edge
of the throat plates.
4. Tighten the setscrews (1).
WARNING
Risk of injury
Crushing injuries from moving parts.
Switch the sewing machine off before you check
and set the stroke movement of the feed-dog.
(1) - Setscrews (2) - Stroke eccentric
①
②
To Next Page
Loading...
