Working basis
Service Manual 867 Version 02.0 - 04/2015 19
Fig. 10: Locking the sewing machine in place
Locking the machine in place
1. Remove the plug from the locking opening (2).
2. Turn the handwheel until the appropriate groove (1) is in front of the
locking opening (2):
• Small groove at handwheel position 0°
• Large groove at handwheel position 200 – 205°
3. Insert the locking peg (3) with the appropriate end into the groove (1).
Removing the locking mechanism
1. Pull the locking peg (3) out of the groove (1).
2. Insert the plug into the locking opening (2).
3.6 Putting the handwheel into position
With some settings, the graduated scale on the handwheel has to be put
into a certain position.
Fig. 11: Putting the handwheel into position
Setting steps
1. Turn the handwheel until the specified number on the graduated
scale (1) is next to the marking (2).
(1) - Groove
(2) - Locking opening
(3) - Locking peg
(1) - Graduated scale (2) - Marking
①
②
To Next Page
Loading...
