Setting the handwheel scale
Service Manual 867 Version 02.0 - 04/2015 21
4 Setting the handwheel scale
Checking the correct setting
1. Lock the machine in place at position 2 ( page 18).
The handwheel is at position 0°.
If a different degree number is next to the marking (2) then you will
have to reset the graduated scale.
Fig. 12: Setting the handwheel scale
Setting steps
The handwheel is fastened using two setscrews, which you can see
through the screw opening (1).
1. Turn handwheel until the first setscrew is under the opening (1)
2. Release the setscrew through the opening (1).
3. Turn the handwheel by 50° such that the second setscrew is under
the opening (1)
4. Release the setscrew through the opening (1).
5. Lock the machine in place at position 2 ( page 18).
6. Turn the handwheel scale so that the 0° is at the center of the marking (2).
7. Tighten the setscrew through the opening (1).
8. Remove the lock ( page 19).
9. Put the handwheel into the 50° position.
10.Tighten the setscrew through the opening (1).
WARNING
Risk of injury
Crushing injuries from moving parts.
Switch the sewing machine off before you check
and set the position of the handwheel on the arm
shaft.
(1) - Screw opening (2) - Marking
To Next Page
Loading...
