DURKOPP ADLER M-TYPE 867 - 12 Sewing Feet; Setting an Even Sewing Foot Stroke

Sewing feet
Service Manual 867 Version 02.0 - 04/2015 53
12 Sewing feet
The two adjusting wheels (3) on the machine arm determine how high the
presser foot (1) and feeding foot (2) are raised during the sewing process.
The left adjusting wheel determines the normal sewing foot stroke. The
right adjusting wheel determines the elevated sewing foot stroke. The ele-
vated sewing foot stroke must not be lower than the normal sewing foot
stroke.
Fig. 40: Presser foot stroke adjusting wheels
12.1 Setting an even sewing foot stroke
Proper setting
For sewing foot stroke 3, the presser foot and feeding foot are raised by
the same height.
Cover
• Arm cover ( 3.3.2 Removing and fitting the arm cover, page 13)
ATTENTION
Machine damage possible if the adjusting wheels are turned using
brute force
Do not attempt to use brute force to set a smaller sewing foot stroke at
the right adjusting wheel.
WARNING
Risk of injury
Risk of crushing injuries and stab wounds from mov-
ing and sharp parts.
Switch off the sewing machine before checking and
setting the sewing foot stroke.
5
6
4
1
2
9
1
2
3
(1) - Presser foot
(2) - Feeding foot
(3) - Presser foot stroke adjusting wheels