Positioning the arm shaft
22 Service Manual 867 Version 02.0 - 04/2015
5 Positioning the arm shaft
Proper setting
The three setscrews (3) on the arm shaft crank (1) are seated completely
on the surface. The arm shaft crank (1) is flush with the machine
casting (2).
Cover
• Arm cover ( 3.3.2 Removing and fitting the arm cover, page 13)
Fig. 13: Setting the arm shaft crank
Setting steps
1. Release all setscrews (3) on the arm shaft crank (1).
2. Turn the arm shaft crank (1) such that the setscrews (3) are seated
completely on the surface of the arm shaft.
3. Push the arm shaft (1) to the right as far as it will go and flush with the
machine casting.
4. Screw all setscrews (3) on the arm shaft crank (1) firmly in place.
WARNING
Risk of injury
Crushing injuries from moving parts.
Switch the sewing machine off before you check
and set the position of the arm shaft crank.
3
1
2
(1) - Arm shaft crank
(2) - Machine casting
(3) - Setscrews
To Next Page
Loading...
