Machines with integrated motor
92 Service Manual 867 Version 02.0 - 04/2015
Attaching
the stator
Fig. 77: Attaching the stator
1. Push the stator with ring (3) onto the shaft, taking care to pay attention
to the ring gap for the cable.
2. Fit the cover plate (2).
3. Evenly screw all three screws (1) firmly in place such that a uniform gap
exists between the cover plate (2) and shaft.
CAUTION
Magnetism!
Work carefully and in a controlled manner, since the
stator can be pulled out of your hands.
(1) - Screws
(2) - Cover plate
(3) - Stator with ring
②
①
③
To Next Page
Loading...
