EasyManua.ls Logo

Dynapac CA3500DCP - Seat Bearing Lubrication and Hydraulic Draining (1000 h)

Dynapac CA3500DCP
178 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Maintenance measures - 500 h
4812165301.pdf 2022-09-02
The engine fuel filter - replacement/cleaning
Fig. Engine compartment
1. Fuel filter
2. Fuel prefilter
2
1
Place a container underneath to collect fuel that
runs out when the filter is released.
Place a container underneath to collect fuel that
runs out when the filter is released.
Screw off the fuel filter (1). The filter is of the
disposable type and cannot be cleaned. Han in to
environment-friendly station.
Refer to the engine manual for detailed
instructions when replacing the fuel filter.
Refer to the engine manual for detailed
instructions when replacing the fuel filter.
Unscrew the lower part of the fuel prefilter (2) and
drain off any water, and then replace the filter unit.
Start the engine and check that the fuel filters are tight.
N.B. Under no circumstances may new fuel filters be
pre-filled with fuel before assembly due to the
demands on the cleanliness of the fuel system. Use
the hand pump on the fuel prefilter to fill from the
machine's fuel system.
136

Table of Contents