EasyManua.ls Logo

Dynapac CA3500DCP - Steering Hitch - Tightening; Replacing the Urea Tank Suction Filter

Dynapac CA3500DCP
178 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Maintenance - 2000h
4812165301.pdf 2022-09-02
Steering hitch - Tightening
Fig. Steering hitch
1. Nut
1
Nobody must be allowed near the steering joint
when the engine is running. Risk of being
crushed when the steering is operated. Switch
off the engine and activate the parking brake
before lubricating.
Nobody must be allowed near the steering joint
when the engine is running. Risk of being
crushed when the steering is operated. Switch
off the engine and activate the parking brake
before lubricating.
The easiest way to identify if you have this type of
steering hitch is that it has a new type of nut (1) at the
top, as shown.
Actual torque (Nm) should be when the machine's
position is straight ahead.
M14 174 NmM14 174 Nm
Replacing the urea tank suction filter
Fig. Urea tank space
The urea tank is located on the right side of the
machine.
Fig. Urea tank
1. Multifunction unit
2. Suction filter
2
1
Loosen and remove the tank multifunction unit (1),
then remove the suction filter (2) that is located in the
bottom of the unit.
Hand in the filter to an environment-friendly waste
disposal station.
Hand in the filter to an environment-friendly waste
disposal station.
Install the new suction filter (2) and refit the
multifunction unit (1) in the tank.
164

Table of Contents