Eaton EASY-E4 Series User Manual

4. Operation
4.6 Transfer program to the easyE4 device
AUTOIP ✓
DHCP
STATIC IP
Table 53: System Option-
s\Ethernet\Address mode
Select the network setting you want.
Set up a new Ethernet connection on your PC's operating system.
To do this, go to Windows Network and Sharing Center and set up a LAN connection
over Internet Protocol Version 4 (TCP/IPv4). Then enter an IP address in the same
range you used for the device, but with a different device number.
Example using Windows
Figure 68: Ethernet connection on PC
You can now connect to your easySoft 7 device with the easySoft 7 programming soft-
ware.
See also
→ Section "Establishing an Ethernet connection", page 532
120
easyE4 11/18 MN050009 EN www.eaton.com

Eaton EASY-E4 Series Specifications

General

Type	Programmable Relay
Digital Inputs	Up to 12
Digital Outputs	Up to 8
Display	LCD
Operating Temperature	-25°C to +55°C
Protection Degree	IP20
Storage Temperature	-40°C to +70°C
Supply Voltage	24 V DC, 100-240 V AC
Analog Inputs	4
Outputs	Relay, transistor
Programming	EASY-SOFT-PRO
Communication	Ethernet, Modbus, CANopen
Expansion	Expandable with additional modules
Relative Humidity	5% to 95% (non-condensing)
Standards	IEC/EN 61131-2, UL 508, CSA C22.2 No. 142