6. Function blocks
6.1 Manufacturer function blocks
This year time switch will switch on on April 1st at 00:00 and after the OFF month
elapses will switch off on November 1st at 00:00. You would configure these settings in
the same channel. Compare this to → "HY - Year time switch (Hora Year)", page 178 for
this time range found below.
Setting time range parameters in which the on phase is from the beginning of the
day to the end of the day for each month in each year (whole day(s)):
First channel ON: 02 -- --, OFF: 25 -- -- means:
The year time switch should switch on at 00:00 h on day 2 of each month, and switch
off when the OFF day has elapsed at 00:00 h on day 26. The parameters are set in one
channel. Refer to the → "HY - Year time switch (Hora Year)", page 178 below for this
time range.
Setting time range parameters in which the on phase is from the beginning of the
day to the end of the day for specified months and years year (day, month, year):
First channel ON: 02 04 25; OFF: 25 09 25 means:
The year time switch will switch on on 04/02/2015 at 00:00:01 and off on 09/26/2029 at
00:00:00. Outside of the configured time range, the time switch will remain off.
Setting overlapping time ranges:
Refer to the → "HY - Year time switch (Hora Year)", page 178 below for these time
ranges.
In these cases, a time cannot be configured for switching, and switching will always
occur for the entire day, from 00:00 to 24:00. This is a set configuration that cannot be
modified at runtime.
easyE4 11/18 MN050009 EN www.eaton.com
183
To Next Page
Loading...
Need help?
General
