Eaton EASY-E4 Series User Manual

2. Installation
2. Installation
CAUTION
Installation requires qualified electrician
easyE4 devices must be installed and wired exclusively by an electrician or a person
who
is familiar with electrical installation rules and practices.
The devices are installed in the following order:
1. Mounting base device
2. Assemble the base device and expansion devices into a block (optional)
3. Connecting the power supply
4. Connecting inputs
5. Connect all outputs (optional)
6. Connect to Ethernet
DANGER OF ELECTRICAL SHOCK!
Dangerous Electrical Voltage!
All installation work must be carried out with the entire installation in a
de-energized state.
Always comply with all applicable country-specific safety rules and regulations:
1. Switch off and isolate
2. Secure against retriggering
3. Verify isolation from the supply
4. Earthing and short-circuiting
5. Covering or providing barriers to adjacent live parts
What to do before turning the device back on
l Remove all tools and materials
l Leave the danger zone
l Remove the short-circuiting and grounding at the area where work was performed
and then elsewhere
l Disconnect the ground wire from the system components first, then from the
ground
l Do not touch system components or cables without a ground wire (if there was one
previously) anymore
l Reinstall all safety covers, safety enclosures, safety labels, and safety signs
easyE4 11/18 MN050009 EN www.eaton.com
37

Eaton EASY-E4 Series Specifications

General

Type	Programmable Relay
Digital Inputs	Up to 12
Digital Outputs	Up to 8
Display	LCD
Operating Temperature	-25°C to +55°C
Protection Degree	IP20
Storage Temperature	-40°C to +70°C
Supply Voltage	24 V DC, 100-240 V AC
Analog Inputs	4
Outputs	Relay, transistor
Programming	EASY-SOFT-PRO
Communication	Ethernet, Modbus, CANopen
Expansion	Expandable with additional modules
Relative Humidity	5% to 95% (non-condensing)
Standards	IEC/EN 61131-2, UL 508, CSA C22.2 No. 142