13. Maintenance
13.3 Storage, transport and disposal
13.3 Storage, transport and disposal
13.3.1 Storage and transport
CAUTION
UV LIGHT
Plastics will become brittle when exposed to UV light. This artificial
aging will reduce the easyE4 unit's lifespan. Protect the device from dir-
ect sunlight and other sources of UV radiation.
CAUTION
SHORT-CIRCUIT HAZARD
If the device is or has been exposed to environmental fluctuations (ambi-
ent temperature, air humidity), condensation may form on or inside it. As
long as this condensation is present, there will be a short-circuit hazard.
Do not switch on the device when it has condensation in or on it.
If the device has condensation in or on it, or if the panel has been
exposed to environmental fluctuations, let the panel settle into the exist-
ing ambient temperature before switching it on.
The ambient conditions must be met when transporting and storing the easyE4.
The ambient air temperature for storage and transportation must not exceed the max-
imum specified limit:
Ambient climatic conditions
Air pressure (in operation) 795 - 1080 hPa
max. 2000 m NHN
Temperature
Operation
- 25 – +55 °C (-13 – +131 °F)
The display is readable between ϑ -5°C (-23°F) ≦ T ≦ 50°C (122°F).
Storage / Transport - 40 – +70 °C (-40 – +158 °F)
Humidity Relative humidity 5 - 95 %
Condensation Prevent condensation by means of suitable measures
Before commissioning
If storing/transporting the device in cold weather conditions or in
such a way that it will be exposed to extreme differences in tem-
perature, make sure that no condensation forms on or inside the
device.
If there is condensation in or on the device, do not switch on the
device until it is completely dry.
Use the original packaging to ship the device.
576
easyE4 11/18 MN050009 EN www.eaton.com
To Next Page
Loading...
Need help?
General
