Eaton EASY-E4 Series User Manual

6. Function blocks
PO - Pulse output → page 284
NET function blocks
GT - Get values from NET → page 339
PT - Put values to NET → page 342
SC - Synchronizing clock via NET → page 346
Other function blocks
AL - Alarm function block → page 349
BV - Boolean operation → page 353
D - Text display → page 357
D - Text display editor → page 366
DL - Data logger → page 380
JC - Conditional jump → page 386
MR - Master reset → page 393
NC - Numerical converter → page 397
ST - SET cycle time → page 403
Interrupt function blocks
Interrupt function blocks are available only in easySoft 7
IC - Counter-controlled interrupt function block → page 405
IE - Edge-controlled interrupt function block → page 418
IT - Time-controlled interrupt function block → page 424
User function blocks – used to create custom function blocks
User function blocks are only available in easySoft 7
UF - User function block → page 432
easyE4 11/18 MN050009 EN www.eaton.com
167

Eaton EASY-E4 Series Specifications

General

Type	Programmable Relay
Digital Inputs	Up to 12
Digital Outputs	Up to 8
Display	LCD
Operating Temperature	-25°C to +55°C
Protection Degree	IP20
Storage Temperature	-40°C to +70°C
Supply Voltage	24 V DC, 100-240 V AC
Analog Inputs	4
Outputs	Relay, transistor
Programming	EASY-SOFT-PRO
Communication	Ethernet, Modbus, CANopen
Expansion	Expandable with additional modules
Relative Humidity	5% to 95% (non-condensing)
Standards	IEC/EN 61131-2, UL 508, CSA C22.2 No. 142