6. Function blocks
6.1 Manufacturer function blocks
Whether you position the function relay first of all in a coil field or contact field or
whether you make the entries in the Parameters tab of a coil or a contact is not import-
ant. It is only important that you have selected the same function block number if you
also want to configure the same function block.
See also
→ Section "BC - Block compare", page 306
→ Section "BT - Block transfer", page 311
→ Section "TB - Table function", page 334
→ Section "MX - Data multiplexer", page 322
→ Section "SR - Shift register", page 326
→ Section "Retention function", page 473
→ Section "Organizing marker ranges", page 163
338
easyE4 11/18 MN050009 EN www.eaton.com
To Next Page
