Eaton easyE4

5. Programming on the device
5.4 Working with contacts and coils
NET operand GT.. (receive), PT.. (send) and SC.. (set date and time)
The function blocks are of data type 32-bit. They will only work if the NET is working
properly.→ Section "Operating system diagnostic messages", page 669
More information about the function blocks: → Section "Function blocks", page 241
NET marker
N.., nB.., nW.., nD...
Every station that the NET marker describes can read any of the other stations.
Fig. 117: 1 slave
Fig. 118: 2 slaves
212
easyE402/24 MN050009ENEaton.com