1. Description of easyE4 control relay
1.9 Safety regulations
1.9.3 Device-specific hazards
CAUTION
DESTRUCTION
The easyE4 should only be opened by the manufacturer or by an
authorized center. Operate the device until only with the enclosure
fully closed and sealed.
CAUTION
ELECTROSTATIC DISCHARGE
Do not touch components (e.g., connector pins) that are electrostatic-
sensitive.
Discharge (by touching a grounded metal object) any static
charge accumulated in your body before touching the device.
Electrostatic discharges may damage or ruin assembly parts. Because
of this, it is necessary to take precautions whenever handling the
cards.
Please refer to the guidelines for electrostatic-sensitive components
for more information (ESD guidelines).
CAUTION
INTERFERENCES
The values specified in the technical data, as well as the device's elec-
tromagnetic compatibility (EMC), cannot be guaranteed if the following
are used: unsuitable cables, improperly assembled and terminated
cables, and/or wiring that does not conform to the applicable stand-
ards.
Only use cables assembled and terminated by professionals.
The cables being used must be assembled and terminated as required
by the port/interface description in this document.
When wiring the devices, follow all instructions regarding how to wire
the corresponding port/interface.
All general Directives and standards must be complied with.
easyE402/24 MN050009ENEaton.com
41
To Next Page
Loading...
Need help?
General