6. Function blocks
6.1 Manufacturer function blocks
If + Call enabled is selected for the function block under Function block dia-
gram/Parameters/, it will be possible to change the switching times in the
PARAMETER menu on the device while in RUN / STOP mode.
Channels A through H are available for an ON or OFF switching operation. The time to
be entered must be between 00:00 and 23:59.
In the example, the ON time on business days is 12:00, and the OFF time is 18:00. A
channel is required for each switching action. Channel A switches on every day of
the week, while channel B switches off.
See also
 → Section "HW - Weekly timer (Hour Week)", page 244
 → Section "HY - Year time switch (Hora Year)", page 254
 → Section "OT - Operating hours counter ", page 264
 → Section "RC - Real-time clock", page 269
 → Section "T - Timing relay", page 272
 → Section "YT - Year time switch (Year Table)", page 284
 → Section "AC - Astronomic clock ", page 295
294
easyE402/24 MN050009ENEaton.com
To Next Page
Loading...
Need help?
General