Eaton easyE4 User Manual

6. Function blocks
6.1 Manufacturer function blocks
The function block and its parameters
Function block inputs
 Description Note
(bit) 
EN
1: Activates the function block.
The checkbox for the
Function block release by EN
is necessary
parameter must first be enabled
SE
The starting value at SV is applied
whenever there is a rising edge at
this input

RE
Reset
1: QV=0

(DWord) 
SH
Counter relay
Integer value range:
-2,147,483,648 to +2,147,483,647


SL
Lower threshold value
SV
Start value (Pre Set)
Assigning operands
You can assign the following operands to the function block inputs that are numeric
inputs.
Operands Value inputs
Constant, timer constant
1)
x
MD, MW, MB - Markers
x
NB, NW, ND - NET markers
2)
x
nNB, nND, nND- NET markers
2)
NET station n
x
IA - Analog input
x
QA - Analog output
x
QV - QV - Numeric output of a FB
x
1)
Only on function blocks T, AC
2)
Only on projects with ≥ 2 base devices on NET
You can assign the following operands to the function block inputs that are bit inputs:
Operands Bit inputs
Constant 0, constant 1
x
M - Markers
x
RN - Input bit via NET
2)
x
SN - Output bit via NET (send)
2)
x
N - Net marker bit
2)
x
nN - NET marker bit
2)
NET station n
x
ID: Diagnostic alarm
x
LE - Output backlight
x
324
easyE402/24 MN050009ENEaton.com

Eaton easyE4 Specifications

General

Brand	Eaton
Model	easyE4
Category	Relays
Language	English