Eaton easyE4 - Page 512

6. Function blocks
6.1 Manufacturer function blocks
Parameter set
 Description Note
Directory name of log session
Enter the name of the folder that
contains the log files here, such as
<MYLOG>. A maximum of 8 char-
acters are allowed, and they must
conform to Microsoft DOS con-
ventions. The default name is
<EASYLOG>.

Storage mode Ring buffer
Until number of log files is
reached

Number of files per log session
A log session contains n log files Integer value range for
1…1000
Number of data sets per log file
A log file contains n data sets Integer value range for
1…60 000
Log when input values change
If the changes at
DL_I are greater than or equal to ΔI
> 0
, a data set will be logged.
ΔI = 0: No logging taking place.
Integer value range for ΔI:
0…65 535
Function block release by
EN is necessary
If this checkbox is enabled, the
state of function block input EN will
be evaluated. If the checkbox is dis-
abled instead, the function block
will be enabled and function block
input EN will not do anything.
This parameter ensures that
when existing programs are
copied, the functionality of the
function blocks that are carried
over will be retained. The para-
meter will be automatically set to
0 or 1 depending on the function
block.
Parameter display
+ Call enabled
Constants can be edited on the
device, as can function block para-
meters when using the EDP pro-
gramming language.

Simulation possible


508
easyE402/24 MN050009ENEaton.com