Eaton easyE4 - 10. easyE4 communication Connection to other devices

9. Operating system diagnostic messages
9.1 Diagnostic messages easy communication module
9.1 Diagnostic messages easy communication module
The following diagnostic alarms can be assigned to base device operands auto-
matically or manually in Project view/Assigned operands.
Diagnostic
alarms
Description
 EASY-COM-
SWD-C1
 EASY-COM-
RTU-M1
PRSNT Expansion present
 ✓  ✓
RUN Cyclical data is active
 ✓  ✓
STOP No cyclical data! (failsafe)
 ✓  ✓
RegMissing
Required module missing (EASY-COM-SWD-C1
only)
 ✓  –
CfgError SWD configuration fault
 ✓  ✓
OptMissing
Optional module missing (EASY-COM-SWD-C1
only)
 ✓  –
ReplByNOP
Module replaced with NOP module (EASY-COM-
SWD-C1 only)
 ✓  –
ReplByComp Module replaced with compatible module
 ✓  –
ERROR Fault Status
 –  ✓
easyE402/24 MN050009ENEaton.com
671