10. easyE4 communication Connection to other devices
10.16 easy communication modules
Programming with easySoft V8 describes how to create an *.e80 project with an easy
communication module
Project creation with easySoft 8
Only available on firmware version 1.30 or higher.
By using an EASY-COM-SWD-… communication module, you can have the easyE4
function as a SmartWire-DT coordinator that coordinates the SmartWire-DT line with
all the modules on the line and manages the data transmission process. This com-
munication module is hereafter referred to as "SmartWire-DT coordinator."
As soon as a SmartWire-DT coordinator is dragged to the left side of the easyE4 base
device in the Project view, the "SWD" tab will appear above the catalog. This tab
shows a list of devices from which you can drag all the SmartWire-DT modules you
need onto the work pane one after the other to create a project with a SmartWire-DT
line.
Please note than only one SmartWire-DT coordinator is allowed per base device!
Fig. 344: Work pane with base device and communication module; catalog expanded with "SWD" tab
easyE402/24 MN050009ENEaton.com
763
To Next Page
Loading...
Need help?
General