3.5 Establishing an Ethernet connection and transferring a pro-
gram or visualization project 117
3.5.1 Basic information on assigning IP addresses 117
3.6 Automatic booting of the memory card 124
3.6.1 Preparing the card in the device for booting with easySoft 8 125
3.6.2 Preparing the card in the easyE4 device for booting with
easySoft 8 129
3.6.3 Preparing the card for booting on the easyE4 device itself 133
3.7 Reset with memory card - reset device to its delivery con-
dition 135
3.8 Updating firmware 136
3.8.1 Firmware Update base device 137
3.8.2 Updating the firmware on expansion devices 140
3.8.3 Updating the firmware on easy communication modules 142
3.9 Functions of the microSD memory card 145
3.9.1 Ejecting the microSD memory card 145
3.10 Setting a splash screen for the EASY-E4-...-12...C1(P) display 146
3.11 Set system parameters using a memory card - e4settings.ini 147
4. Operation 153
4.1 Base device with display and buttons 153
4.1.1 LCD Display 153
4.1.1.1 Display color backlight 154
4.1.2 Keyboard 154
4.1.3 Selecting menus and entering values 155
4.1.4 Cursor display 156
4.1.5 Entering of values 156
4.2 Operating modes of the easyE4 157
4.2.1 RUN mode 157
4.2.2 STOP mode 157
4.3 Operation of the menu selection and value entry 159
4.3.1 How to navigate the device menus 159
4.3.2 Operating principle in the circuit diagram and function block
editor 159
4.3.3 Selecting a device menu 160
4
easyE402/24 MN050009ENEaton.com
To Next Page
Loading...
Need help?
General